Before Operation; Setting The Clock - Sharp R-68ST Manual De Instrucciones Y Recetario

R-68ST_EN.qxd 7/27/07

BEFORE OPERATION

Plug in the oven.
1. The oven display will flash:
2. Press the STOP button, the display will show:
x1
3. To set the clock, see below.
4. Heat the oven without food.

SETTING THE CLOCK

There are two setting modes: 12 hour clock and 24 hour clock.
1. To set the 12 hour clock, hold the MICROWAVE POWER LEVEL button down
for 3 seconds. "12 H" will appear in the display.
2. To set the 24 hour clock, press the MICROWAVE POWER LEVEL button once
more after Step 1, in the example below "24 H" will appear in the display.
To set the clock, follow the example below.
Example:
To set the 24 hour clock to 23:35.
1. Choose the clock function.
(12 hour clock).
x1 and hold for 3 seconds
3. Press the MICROWAVE
POWER LEVEL button to
change from hours to
minutes.
x1
NOTES:
1. You can rotate the TIMER/WEIGHT knob
clockwise or counter-clockwise.
2. Press the STOP button if you make a mistake
during programming.
3. If the electrical power supply to your microwave
oven is interrupted, the display will intermittently
12:20 PM Page 4
(See page GB-7, Note b).
Choose the 24 hour
clock.
x1
4. Set the minutes. Rotate the
TIMER/WEIGHT knob until
the correct minute is
displayed (35).
Using the STOP button
Use the STOP button to:
1. Erase a mistake during programming.
2. Stop the oven temporarily during cooking.
3. Cancel a programme during cooking, touch twice.
2. Set the hours. Rotate the TIMER/WEIGHT
knob until the correct hour is displayed (23).
5. Press the MICROWAVE POWER
LEVEL button to start the clock.
x1
show "88:88" after the power is reinstated. If this
occurs during cooking, the programme will be
erased. The time of day will also be erased.
4. When you want to reset the time of day, follow the
above example again.
GB-4
x1 and hold
for 3 secs.