Control Panel - Yamaha DPX-1 Manual De Instrucciones

I Control panel
Control panel <on the rear>
1
1
indicator (P.14)
2 STANDBY/ON button (P.10)
Secondary power button
Turns on and sets this unit in the standby mode. This button is
effective only when the primary power switch is turned on.
Standby mode
In this mode, this unit consumes a small amount of power to
receive infrared siganls from the remote control.
3 LAMP/COVER indicator (P.14)
4 TEMP/FAN indicator (P.14)
5 FILM indicator (P.14)
6 INPUT button (P.11)
Turns on and off the menu to select the input terminal and the
input signal.
Rear remote control
sensor
STANDBY/ON
INPUT
LAMP
TEMP
/COVER PATTERN
/FAN
FILM
2 3 4 5 6 7
Power switch
Primary power switch.
" " turns on and sets this unit in the
standby mode.
" " turns off this unit.
STANBY/ON INPUT
LAMP TEMP PATTERN
/COVER /FAN FILM
Ventilation (intake) slots / filter
covers
Adjusters
To fine-adjust the projection angle
SELECT
ESCAPE
MENU
8 9 0 q
7 PATTERN button (P.10)
Turns on and off the stored test patterns on the screen.
8 MENU button (P.18)
Turns on and off the menu to set or adjust the parameters
necessary for projection.
9 ESCAPE button (P.18)
Closes the submenu.
0 Cursor buttons (P.18)
Used for the operation of h, g, –, and +.
q SELECT button (P.18)
Confirms the new setting entry, or opens the submenu.
Controls and functions
AC inlet
To plug in the supplied power cord.
ESCAPE SELECT
MENU
3
E-