Connecting The Power Terminal - Pioneer GM-D9605 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section
Connecting the units
03

Connecting the power terminal

WARNING
If the battery wire is not securely fixed to the term-
inal using the terminal screws, there is a risk of
overheating, malfunction and injury, including
minor burns.
! Always use the recommended battery and
ground wire, which is sold separately. Con-
nect the battery wire directly to the car bat-
tery positive (+) terminal and the ground
wire to the car body.
! Recommended wires size (AWG: American
Wire Gauge) is as follows. The battery wire,
the ground wire and the optional direct
ground wire must be same size.
! Use a wire of 8 AWG to 16 AWG wire for the
speaker/subwoofer wire.
Battery wire and ground wire size
Wire length
less than 2.2 m (7 ft
3 in.)
less than 3.6 m (11 ft
10 in.)
less than 6.4 m (20 ft
12 in.)
1
Route battery wire from engine com-
partment to the vehicle interior.
! When drilling a cable pass-hole into the ve-
hicle body and routing a battery wire thor-
ough it, take care not to short-circuit the
wire damaging it by the cut edges or burrs
of the hole.
After completing all other amplifier connec-
tions, finally connect the battery wire terminal
of the amplifier to the positive (+) battery
terminal.
2
1
12
En
Wire size
8 AWG
6 AWG
4 AWG
3
1 Positive (+) terminal
2 Battery wire (sold separately)
The maximum length of the wire between
the fuse and the positive + terminal of the
battery is 30 cm (12 in.).
3 Fuse (100 A) (sold separately)
Each amplifier must be separately fused at
100 A.
2
Use wire cutters or a utility knife to
strip the end of the battery wire, ground
wire and system remote control wire to ex-
pose about 10 mm (3/8 in.) of the end of
each of the wires, and then twist the ex-
posed ends of the wires.
3
Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
6
4
1 Battery wire
2 Power terminal
3 Ground wire
4 Ground terminal
5 System remote control wire
6 System remote control terminal
7 Terminal screws
Twist
10 mm (3/8 in.)
7
2
1
3
5

Publicidad

Tabla de contenido
loading

Tabla de contenido