To Start The Product With A Warm Engine - Husqvarna K 770 Vac Manual Del Usuario

3. Push the decompression valve to decrease the
pressure in the cylinder. The decompression valve
goes back to its initial position when the product
starts.
4. Push the air purge bulb 6 times until it is fully filled
with fuel.
5. Hold the front handle with your left hand.
6. Put your right foot on the lower section of the rear
handle to push the product against the ground.
20
WARNING: Do not wind the starter rope
around your hand.
7. Pull the starter rope slowly with your right hand until
you feel a resistance as the starter pawls engage.
Then pull continuously and quickly.
CAUTION: Do not pull the starter rope
fully and do not let go of the starter rope
handle when the starter rope is
extended. This can cause damage to the
product.
8. Push the choke control when the engine starts. If the
choke is pulled out, the engine will stop after some
seconds. If the engine stops, pull the starter rope
handle again.
9. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.
To start the product with a warm
engine
WARNING: Make sure that the cutting blade
can rotate freely. It starts to rotate when the
engine starts.
705 - 002 - 12.11.2018