To Remove The Spring Assembly - Husqvarna K 770 Vac Manual Del Usuario

1. Hold the starter rope pulley with your thumb. Pull the
starter rope approximately 30 cm and put it in the
cut-out of the starter pulley.
2. Let the rope pulley rotate slowly in the opposite
direction to release the spring tension.
3. Remove the remaining starter rope.
4. Do a check that the recoil spring operates correctly.
5. Put the new starter rope through the hole in the
starter housing and in the rope pulley.
6. Attach the starter rope to the rope pulley.
7. Tighten the connection fully. Make sure that the free
end of the starter rope is as short as possible.
8. Attach the end of the starter rope in the starter
handle as shown in the illustration.
705 - 002 - 12.11.2018
To adjust the tension of the recoil
spring
1. Put the rope through the cut-out in the starter pulley.
Wind the rope 3 turns clockwise around the center of
the starter pulley.
2. Pull the starter knob to adjust the tension of the
recoil spring.
3. Put the rope through the cut-out in the starter pulley.
Wind the rope 4 turns clockwise around the center of
the starter pulley.
4. Pull the starter knob to adjust the tension of the
recoil spring.
Note: The starter knob goes to its correct start
position after adjusting the tension of the recoil
spring.
5. Do a check that the recoil spring is not at its end
position by pulling out the starter rope fully. Make the
starter pulley go slow with your thumb. Make sure
that the starter pulley can be turned half a turn or
more before the recoil spring stops the movements.

To remove the spring assembly

WARNING: Always use eye protection when
you disassemble the spring assembly. There
is a risk for eye injury, especially if a spring
is broken.
25