Husqvarna K 770 Vac Manual Del Usuario página 8

2. Push the throttle lockout and make sure it goes back
when you release it.
3. Make sure that the throttle trigger and throttle lockout
move freely and that the return springs work
correctly.
4. Start the product and apply full throttle.
8
5. Release the throttle control and make sure that the
cutting blade stops and stays stationary. If the
cutting blade rotates at idle position, you must adjust
the idle speed. Refer to
page 26 .
To examine the stop switch
1. Start the engine.
2. Push the start/stop switch to the STOP position. The
engine must stop.
Blade guard, blade guard extender and dust shield
WARNING: Make sure that the blade guard,
the blade guard extender and the dust shield
are correctly attached before you start the
product. Do not use the product if the blade
guard, the blade guard extender or the dust
shield are missing, cracked or defective.
• The blade guard, the blade guard extender and the
dust shield keep dust away from the operator and
prevent injury if the cutting blade breaks. The blade
guard extender and the dust shield are spring loaded
To adjust the idle speed on
705 - 002 - 12.11.2018