To Install The Starter Housing; To Lubricate The Spring Assembly; To Attach The Spring Assembly - Husqvarna K1270 II Manual Del Usuario

is a risk for eye injury, especially if a spring
is broken.
1. Remove the bolt in the center of the starter pulley
and remove the starter pulley. Carefully remove the
cover.
The recoil spring has tension in the starter housing.
2. Carefully remove the spring. Use a pair of pliers.

To lubricate the spring assembly

• Lubricate the recoil spring with light oil.

To attach the spring assembly

• Assemble in the opposite sequence of
the spring assembly on page 33 .
34

To install the starter housing

1. Put the starter against the product.
2. Install the starter pawls into the correct position
against the starter pulley sleeve. Pull out the starter
rope approximately 0.5 m. (A). If the position is
correct, you hear a click sound (B).
B
3. Slowly release the starter rope.
4. Tighten the 4 screws on the starter
To remove
CAUTION: The starter pawls must come into
the correct position against the starter pulley
sleeve.
A
988 - 002 -