To Adjust The Tension Of The Drive Belt - Husqvarna K1270 II Manual Del Usuario

6. Remove the nut on the rear belt guard and remove
the rear belt guard.
7. Replace the drive belt.
8. Assemble in opposite sequence. To install the
cutting blade, refer to
page 14 .
30
To install the cutting blade on

To adjust the tension of the drive belt

The tension of the drive belt is correct when the
adjustment nut is opposite the mark on the drive belt
cover.
1. Loosen the 2 bolts that hold the cutting head to the
cutting arm.
988 - 002 -