Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FIGURE 1
(FS 6500 Shown)
1A.
KNOB: Use to tighten operator grip handles.
1B.
HANDLE BARS: For operator gripping.
1C.
FUEL TANK FILL: Fill the fuel tank at this
location.
1D.
OIL PRESSURE GAUGE: Shows the engine oil
pressure (Not available on 40 or 35 Models).
1E.
WATER SAFETY SWITCH:
the water supply to the blade is interrupted. Push
to reset. (Not available on Pro 65 Basic Model)
1F.
VOLTAGE GAUGE: Shows the voltage of the
electrical system. (Not available on Pro 65 Basic
Model)
1G.
FUEL GAUGE: Shows level of fuel in tank.
1H.
ENGINE TACHOMETER: Shows the engine
RPM's. (Not available on Pro 65 Basic Model)
1I.
ENGINE START SWITCH: Start the engine
using this switch.
1J.
BLADE DEPTH STOP: Sets the depth stop for
repetitive cuts at the same depth. (Not available
on Pro 65 Basic Model)
1K.
BLADE DEPTH INDICATOR:
depth.
1L.
LIGHT SWITCH: Controls the lights for the
gauges. (Not available on Pro 65 Basic Model)
1M.
WATER PUMP SWITCH: Optional
20
1N.
1O.
1P.
1Q.
1R.
1S.
Stops the engine if
1T.
1U.
1V.
1W.
1X.
1Y.
Displays cutting
1Z.
PARKING BRAKE SWITCH:
AUTO POSITION - With the engine start switch
in the "RUN" position, the brake is automatically
engaged when the transmission is shifted into
neutral and automatically disengaged when the
transmission is shifted from neutral into gear.
"OFF" POSITION - With the engine start switch
in the "RUN" position, the brake is disengaged
to allow the machine to be pushed.
NOTE: Anytime the engine start switch is in the
"OFF" position, the parking brake is engaged.
(Not available on Pro 65 Basic Model)
WATER INLET:
ENGINE THROTTLE:
ENGINE CHOKE: Gas Models Only
RED BUTTON: Located on speed control lever.
Use to raise and lower the saw. Press the upper
part of the button to raise saw upward. Press the
lower part of the button to lower the saw.
SPEED CONTROL LEVER: Controls forward
and reverse directions, stop, and the speed of the
saw. Also shifts the transmission from low /
neutral / drive.
RED PALM SWITCH: For EMERGENCY STOP
of the saw. Stops all systems except lights and
engages parking brake. Twist to reset. Do not
use for routine stopping.
WATER OUTLET:
NEUTRAL POSITION: The saw will stop travel
movement when the speed control lever (1S) is in
this position. The engine will not start unless the
Speed Control Lever (1S) is in the NEUTRAL
position.
PRE-CLEANER:
AIR FILTER:
AIR RESTRICTION INDICATOR:
(Not available on Pro 65 Basic Model)
WATER VALVE:
Publicidad
Tabla de contenido
