Ice And Water Dispenser - Bosch 4 Serie Manual De Uso

Fault
Appliance has no cooling
capacity. The interior light
does not function.
The refrigerating unit
switches on more and more
frequently and for longer.
The temperature in the
refrigerator or freezer
compartment is too cold.
The frozen food is stuck
solid.

Ice and water dispenser

Fault
Ice cubes are not being
dispensed despite prolonged
operating time.
Ice cubes are in the ice cube
container, but are not being
discharged.
Ice cubes have become
wedged in the outlet of the
ice cube container or in the
ice crusher.
Ice cubes are watery.
Water dispenser is not
functioning.
Ice maker is not making
enough ice or the ice is
deformed.
Possible cause
Power failure; the fuse has actuated;
the mains plug is not in properly.
Appliance door opened frequently.
Large quantities of fresh food
placed in the appliance.
The ventilation openings have been
covered.
Temperature has been set too low.
Possible cause
Tap turned off.
Water supply is interrupted. Water
pressure too low.
Ice maker is disconnected.
Ice and water dispenser is switched
off. "IWD off" is lit on the display
panel.
Freezer compartment too warm.
Ice cubes are frozen together.
Ice cubes have thawed – power
failure or the freezer compartment
door was not closed properly.
Tap turned off.
Water supply is interrupted. Water
pressure too low.
Appliance or ice maker was only
switched on recently.
A large amount of ice was removed.
Remedial action
Check that the power is on. The fuse
must be switched on. Check that the
mains plug is plugged in.
Do not open the door unnecessarily.
Switch on Super function.
Remove obstacles and dirt.
Select a warmer temperature
(see "Selecting the temperature").
Loosen frozen food with a blunt
implement. Do not use a knife or
pointed implement!
Remedial action
Turn tap on.
Inform fitter.
Switch on ice maker again (see
"Disconnecting the ice maker").
Switch on ice and water dispenser
again (see "Switching off ice and water
dispenser").
Lower temperature in the freezer
compartment (see "Selecting the
temperature").
Take out ice cube container and
empty.
Take out ice cube container and rotate
feed screw by hand. Loosen any
wedged chunks of ice with a wooden
stick.
Take out ice cube container, empty
and wipe dry.
Turn tap on.
Inform fitter.
It take approx. 24 hours for ice
production to start.
It take approx. 24 hours for the ice
cube container to fill up again.
23