Maintenance; General; Changing The Drill Bit; Cleaning - Husqvarna DM 230 Manual De Instrucciones

General

WARNING! Inspection and/or
!
maintenance should be carried out with
the motor switched off and the plug
disconnected.
The lifetime of your machine can be extended
considerably if it is used, cared for and maintained in the
proper manner.

Changing the drill bit

1 Pull out the plug.
2 Get:
- The new drill bit.
- The supplied open-ended spanners, size 24 mm and
32 mm.
- Water-resistant grease.
3 Remove the old drill bit using the open-ended
spanners.
4 Apply water-resistant grease to the thread of the new
drill bit.
5 Attach the drill bit using the open-ended spanners.
Before the machine is started, carefully check that the
new bit is firmly attached.

MAINTENANCE

Cleaning

• Keep the machine and drill bit clean in order for drilling
to be carried out safely.
• Keep the handle dry and free of grease and oil.
• In order for the machine to always be cooled
sufficiently the cooling air openings must be kept clear
and clean. Blow down the machine regularly with
compressed air.
• Use compressed air to periodically clean the motor.
Remove the inspection cover and clean the cover.

Water tap

Check that the water tap functions. Do not use hoses that
are distorted, worn or damaged.

Electrical Feed

!
Check that the cord and extension cord are intact and in
good condition. Never use the machine if the cord is
damaged, hand it in to an authorized service workshop for
repair.

Repairs

Important All types of repairs may only be carried out by
authorised repairmen. This is so that the operators are
not exposed to great risks.
WARNING! Never use damaged cables.
They can cause serious, even fatal,
personal injuries.
–
English 13