Checking, Maintaining And Servicing The Machine ' S Safety Equipment - Husqvarna DM 230 Manual De Instrucciones

Power switch
The power switch should be used to start and stop the
machine.
Power switch lock
The power switch lock is designed to prevent accidental
operation of the switch. When the lock (A) is pressed in
the power switch (B) is released.
The power switch lock remains depressed as long as the
power switch is depressed. When the grip on the handle
is released both the power switch and power switch lock
are reset. This movement is controlled by two
independent return springs. This position results in the
machine stopping and the power switch being locked.
Ground fault circuit interrupter
Ground fault circuit interrupters are for protection in case
an electrical fault should occur.
The LED indicates that the ground fault circuit interrupter
is on and that the machine can be switched on. If the LED
is not on, push the RESET button (green).
10 – English
SAFETY INSTRUCTIONS
Checking, maintaining and
servicing the machine' ' ' ' s safety
equipment
IMPORTANT! All servicing and repair work on the
machine requires special training. This is especially true
of the machine's safety equipment. If your machine fails
any of the checks described below you must contact
your service agent. When you buy any of our products
we guarantee the availability of professional repairs and
service. If the retailer who sells your machine is not a
servicing dealer, ask him for the address of your nearest
service agent.
Checking the power switch
Start the machine, release the power switch and check
that the motor and the drill bit stop.
A defective power switch should be replaced by an
authorized service workshop.
Checking the power switch lock
Press the power switch and check that the power switch
is locked when the power switch lock is pressed in.
Press in the power switch and make sure the switch
returns to its original position when you release it.
Check that the power switch and the power switch lock
move easily.