Troubleshooting - Husqvarna PG 830S Manual Del Usuario

4. Push the chassis fully against the grinding head (C).
Make sure that the chassis attaches to the bracket
on the grinding head.
C
5. Install the second bracket (D) on top of the bracket
on the grinding head.
6. Tighten the 2 nuts (E) on each side of the grinding
head.
Problem
The product does not
start.
20
D

Troubleshooting

Cause
The extension cable is disconnected or dam-
aged.
An emergency stop button is engaged.
The safety switch is open in the electrical en-
closure.
7. Connect the motor cable to the electrical outlet (F)
on the electrical enclosure.
F
E
8. Lock the motor cable to the electrical outlet (G) on
the electrical enclosure.
9. Remove the grinding head in opposite sequence.
Solution
Connect the extension cable or if it is neces-
sary, replace the extension cable.
Turn the emergency stop button on the con-
trol panel clockwise to disengage.
Close the safety switch to complete the cir-
cuit.
G
1253 - 003 - 22.01.2020