Bosch MUC1 Serie Instrucciones De Uso página 26

en Use
Some programmes consist of several pro-
gramme steps. The respective programme
step is shown in the display. Once a step is
finished, a recurring signal tone sounds and
the display and button G flash. Add ingre-
dients depending on the recipe, and press
button G again. The following preparation
step will start.
Depending on the programme selection
or the preparation step, the lid should be
closed or open. Please see the AutoCook
app for more details here.
Selecting and starting the
programme
Warning!
– Do not fill the pan beyond the marking
[4.0 litres]!
– Use only plastic utensils for stirring
(do not use metal utensils).
Important: Take note of the safety instruc-
tions at the beginning of the manual.
X Image sequence E
1. Keep pressing button D until the
desired preparation programme is
selected. The corresponding LED lights
up in the control panel and the pre-con-
figured preparation time for the selected
preparation programme flashes.
2. Press button E to change the
pre-configured preparation time. The
display changes from [medium] to [long]
and then to [short ] before returning to
[medium]. The pre-configured prepara-
tion time is shown in the display.
3. Open the lid and add the required ingre-
dients depending on the recipe.
4. Depending on the preparation pro-
gramme, close the lid.
5. Press button G to start the preparation
programme.
6. The appliance heats up the pan until the
target temperature is reached. During
the heating phase, lines that light up
in a clockwise direction appear in the
display.
26
7. Once the target temperature is reached,
the lines go out and the remaining
preparation time is shown in the display.
Note: For programmes with several prepa-
ration steps, once the target temperature
has been reached or once the preparation
step is completed, a signal tone sounds.
Add further ingredients and press button G
to start the next preparation step.
8. When the preparation programme ends,
a signal tone sounds, and the indicator
[finished] and button G light up. The
display flashes and shows "00:00".
Note: For some programmes, once com-
plete, the keep warm function is automati-
cally activated. The indicator [keep warm]
lights up.
9. Press button B to switch to standby
mode. Disconnect the mains plug.
10. Serve the finished dish and let the appli-
ance cool down completely.
■ Once it has cooled down completely,
clean all of the parts. X "Cleaning and
maintenance" see page 29
Prematurely terminating the
current preparation step
If the ingredients are cooked ahead of time
during one of the preparation steps, the
step can also be terminated manually.
■ Press button G for at least 2 seconds.
■ This will terminate the current prepara-
tion step. A signal tone will then sound
once the next step can be carried out.
■ In the control panel, LEDs 1, 2, 3 or 4
are shown accordingly and button G
flashes.
■ Press button G to start the next prepa-
ration step.
Prematurely terminating the
preparation programme
■ Press button H to end the preparation
programme.