•
Clean the air filter by placing it in a bag and shaking
the dust off. Do not use compressed air or any sharp
objects to clean the air filter as this can cause damage
to the filter.
•
The filter is a conical shape and the wider section
should be at the top of the filter container.
•
Replace the filter container in its guide groove on the
handle.
•
Tighten the container using the clamping brackets.
•
Connect the hose connector to the filter container.
•
Screw on the handle with the knob.
Washing the filter
The filter is made of a polyester material and can be
washed with water as necessary. Change filter after 500
hours or after 6 months.
•
In order to avoid destruction of the finish or ePTFE
membrane clean the filter elements with a gentle soft
jet of water. A strong/sharp jet will destroy the ePTFE
membrane. The cleaning can be supported by a soft
brush.
•
Wash the filter elements from top to bottom. Avoid
rubbing or scrubbing on selected spots.
•
Dry the filter elements carefully. Approximately one
week at a temperature of 15-20 °C, or at 70 °C during
16 – English
MAINTENANCE
14 hours in the oven. It is important that they are 100%
dry.
•
After washing in above mentioned way, the filter
elements can be used again at low pressure drop. The
life time after washing is approximately 60-70 % of the
life time in new condition.
NOTICE! Ensure that the filter is dry before refitting it.
Cleaning of cyclone cone
•
Remove the cyclone cone by turning it
counterclockwise.
•
Turn the cyclone cone over and empty the dust and
debris on the floor.
•
Inspect the gaiter inside the filter container and clean
if necessary.