Joystick Y , Remote Control; Machine Disc , Operating Panel; Machine Head , Operating Panel; Pair The Remote Control With The Machine - Husqvarna PG820 RC Manual De Instrucciones

• To calibrate "CENTER" (A), release the joystick so
that it springs back to center position (B) and confirm
with "OK" (C).
MINIMUM
A
0% (50%)
CENTER
50%
MAXIMUM
100%
C
• Return to the previous menu with the 'Back' key.

JOYSTICK Y , remote control

• Calibrated the same way as 'JOYSTICK X' but with the
joystick moved up and down respectively.

MACHINE DISC , operating panel

• Calibrated the same way as 'DISC'.

MACHINE HEAD , operating panel

• Calibrated the same way as 'DISC'.
Jan 05 12:45
OPERATING
Pair the remote control with the
machine
If the accompanying remote control is exchanged or if it is
necessary to swap remote controls between two units, the
remote control must be rematched with the relevant unit.
• Connect the remote control using the supplied CAN-
B
cable. Tighten the cable connector screws by hand.
• Allow the remote control to fully charge and await the
home screen.
• Press the "OK" button to access the menu.
• Go to "PAIR RADIO". Browse with the arrow keys and
confirm with "OK".
SETTINGS
SERVICE
A message is displayed on the screen to indicate if the
pairing was successful or not. Try again if the pairing fails.
Jan 05 12:45
STOP WATCH
PAIR RADIO
RADIO CHANNEL
[ 3 ]
LANGUAGE
[ ENGLISH ]
Jan 05 12:45
–
English 21