Overview
Please fold out the illustrated pages.
Blender attachment
X Fig. A
1 Glass blender jug
a Container made of ThermoSafe glass
b Scale
c Blade holder
d Marking
2 Lid
a Filling opening
b Locking cap /
measuring jug with scale
c Notch for blade insert
3 Blade insert
a Blade drive
b Blender knife
c Seal
d Marking
Before using the appliance
for the first time
Before the new accessory can be used,
it must be fully unpacked, cleaned and
checked.
Caution!
Never operate a damaged accessory!
■ Remove all accessories from the
p ackaging and dispose of all packing
m aterials.
■ Check that all parts are present and
examine them for obvious damage.
X Fig. A
■ Thoroughly clean and dry all parts
before using for the first time.
X "Cleaning and maintenance" see
page 10
Symbols and markings
Symbol
Meaning
Marking on the blade insert
when inserting in the blade
holder.
Marking on the blade holder
when inserting on the food
processor.
Glass blender jug
The "ThermoSafe" glass blender jug is
made of special, highly heat-resistant
borosilicate glass. This lets you process
very hot, even boiling ingredients. The glass
blender jug is suitable for processing the
following quantities:
Maximum processing quantities
Solid food
Liquids
Hot or frothing liquids
Preparation
W Risk of injury
Do not reach into the blender knife. Grip the
blade insert by the plastic only.
Caution!
Never use the blade insert without the seal.
X Image sequence B
1. Fit the seal on the blade insert.
2. Turn the blade insert over.
3. Turn the blender jug over.
4. Fit the blade insert into the blade
holder. Observe the marking (,) when
doing so.
5. Fit the locking cap of the lid. When
doing so, observe the notch.
6. Use the locking cap to rotate the blade
insert clockwise to the stop (;).
7. Remove the locking cap.
Overview
en
max. 100 g
max. 0.8 l
max. 0.4 l
9