Husqvarna R 418Ts AWD Manual De Usuario página 27

2. Lock the blade with a wooden block.
3. Loosen and remove the blade bolt, the washers and
the blade.
4. Assemble the new blade with the angled ends in the
direction of the cutting deck.
WARNING: Incorrect blade type can
cause objects to eject from the cutting
deck and cause serious injury. Use only
the blades given in
page 35 .
5. Attach the blade, the washer and the bolt. Tighten
the bolt with a tightening torque of 45-50 Nm.
To do a check of the engine oil level, R
418Ts AWD
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in. Do not tighten it.
6. Pull the dipstick out and read the oil level.
522 - 002 -
Technical data on
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole that the dipstick sits in.
Fill the oil slowly.
Note: See Technical data on page 35 of engine oil
recommended. Do not mix different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
To do a check of the engine oil level, R
422Ts AWD
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in. Do not tighten it.
6. Pull the dipstick out and read the oil level.
27