To Apply And Release The Parking Brake; To Get A Good Cutting Result; Maintenance; Maintenance Schedule - Husqvarna R 418Ts AWD Manual De Usuario

1. Pull the hydraulic lift lever for the cutting deck
rearward to lift the cutting deck to transport position.
The blades stop to rotate.
2. If necessary, pull the mechanical lift lever for the
cutting deck rearward to lock the cutting deck in
transport position.
Note: The engine can not be started again if the
mechanical lift lever is not in transport position.
3. Turn the ignition key to the STOP position.
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.

Maintenance schedule

* = General maintenance done by the operator. The
instructions are not given in this operator's manual.

Maintenance

Make sure that nuts and screws are tightened
Make sure that there are no fuel or oil leaks
To clean the product on page 19
Clean as given in
522 - 002 -
4. When the product stops, apply the parking brake.

To apply and release the parking brake

1. Press the parking brake pedal down (1).
2. Press and hold the lock button (2).
3. Keep the button pressed and release the parking
brake pedal.
4. To release the parking brake, press the parking
brake pedal again.

To get a good cutting result

• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, see
35 ). Move the product forward at low speed. If the
grass is not too high and thick, you can get a good
cutting result also at a higher speed.
• To get the best cutting result, cut the grass
frequently and use the BioClip function.
Maintenance
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Note: If more than one time interval is identified in the
table, the shortest time interval is for the first
maintenance only.
Daily, before
operation
*
*
X
2
1
Technical data on page
Weekly Maintenance interval
in hours
25 50 100 200
17