Fulgor Milano SUPREME SO 6115 Instrucciones Para La Instalación Y Uso página 20

GB
Touching any keys will not cause any acoustic feedback.
Failure declarations and error codes
The control is continuously checking the status of the system. If an abnormal condition is
detected for more than 1 minute, a failure occurs:
- The heaters and the other loads are disabled.
- The display shows a "E" letter flashing, followed by a numeric code that depends on
the kind of failure.
- The control emits an acoustic warning signal that will last for some minutes.
To reset a failure declaration, first remove the cause of the failure then touch the [H] key
(OFF).
Error code table.
Error
E001
E004
E008
E016
E017
E032
18
Description
Temperature sensor shorted.
Electronic boards over temperature
Latch time-out overflow.
Oven cavity overheating
Temperature sensor disconnected or broken
Wrong oven model configuration