Installation Of The Oven; Electricals - Fulgor Milano SUPREME SO 6115 Instrucciones Para La Instalación Y Uso

GB

INSTALLATION OF THE OVEN

To install the oven into the kitchen a cutout should be made in accordance with the
dimensions shown in Fig. 1.
The apparatus is to be fastened to the top by means of the two screws provided in the kit
through the holes made on the oven uprights.
The cabinet in which the apparatus is installed shall be open on the back side to ensure
a sufficient air circulation and prevent overheating.
Leave a gap of at least 200 cm2 (see Fig. 1) for air circulation if the oven is installed in a
column; this is not necessary if the oven is installed under the work top.
As the apparatus is to be fitted in your kitchen furniture, make
sure that all surfaces in contact with the oven can resist a
temperature of approx 90°C.

Electricals

- Absorbed power:
oven top element:........................................................... 2400W 230V - 2400W 240V
oven bottom element: .................................................... 2100W 230V - 2100W 240V
round element (hot air): .................................................. 2500W 240V (on some models)
roasting jack motor: ....................................................... 4 W (on some models)
lamp: .............................................................................. 25 W
hot air fan motor:............................................................. 25 W
cooling fan motor:............................................................ 25 W
- Maximum absorbed power: (see data plate).
- Supply voltage: (see data plate).
This appliance is in compliance with following European directives:
2006/95/CE (LVD), 2004/108/CE (EMC), 2011/65/CE (RoHS),
2012/19/UE (WEEE), 2002/40/CE.
4
WARNING
NOTE