Select Cycle; Pull Control Dial Out To Start - Maytag MAV-2 Guía De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP
4

Select Cycle

To select a cycle, push the control dial in and turn it to
the right (clockwise) until the pointer is at the soil level
needed for the wash load.
IMPORTANT: For optimum fabric care, the
appropriate wash and spin speed for the load type
must be selected using the wash/Spin Speed knob.
Regular Cycle
This cycle provides up to 16 minutes of agitation.
Select the Regular Wash/Spin Speed setting.
Perm Press
This cycle is designed for sturdy fabrics needing a
slower spin speed to reduce wrinkling, such as dress
shirts and dress pants.
Select the Permanent Press Wash/Spin Speed
setting.
Delicates Cycle
This cycle is designed for items requiring delicate wash
action. Select the Delicate Wash/Spin Speed setting.
When washing delicate fabrics labeled hand wash,
select the Handwash Wash/Spin Speed setting. This
setting provides intermittent slow agitation and soak
with a slow spin.
Cycles and options vary by model.
Cycles and options vary by model.
STEP
5
Select Options
Extra Rinse
When the switch or knob is in the On position, an
additional rinse at the end of the Regular, Permanent
Press and Delicates cycles is provided to more
completely remove laundry additives, suds, perfumes,
etc.
End of Cycle Signal (select models)
The end of cycle signal will sound once the cycle is
completed. On select models, the end of cycle signal
can be canceled by setting the switch to Off.
STEP
6

Pull Control Dial Out to Start

You may stop the washer at any time by simply
pushing the control dial in. Therefore it is possible to
obtain a non-agitated soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed in (off position) when you change the setting.
Note:
Do not attempt to turn the control dial
counterclockwise. Damage to the timer will result.
(if desired)
6

Publicidad

Tabla de contenido
loading

Tabla de contenido