Maintenance; Troubleshooting - Delta 36-5000 T2 Manual De Instrucciones

To reduce the risk of injury, turn unit off and disconnect it from power source before cleaning or servicing, before installing and
removing accessories, before adjusting and when making repairs. An accidental start-up can cause injury.
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed
air. All plastic parts should be cleaned with a soft damp cloth.
NEVER use solvents to clean plastic parts. They could possibly
dissolve or otherwise damage the material.
LUBRICATION & RUST PROTECTION
Apply hardwood flooring paste wax to the machine table
occasionally or use a commercially available protective
product designed for this purpose. Follow the manufacturer's
instructions for use and safety.
MAINTENANCE REMINDERS
Wear certified safety equipment for eye, hearing and
respiratory protection while using compressed air.
Specific areas which require regular maintenance include:
RIVING KNIFE CLAMP PLATE:
debris buildup. Blow out area regularly with compressed air.
NOTE: If the riving knife clamp can't move freely, have
the saw serviced by authorized DELTA
Corporation service center personnel.
ADJUSTING BELT TENSION
1.
Lower the blade height to its lowest position.
2.
Loosen the torx screw (A) that is used to mount the
motor housing. This should be loosened enough to feel
the motor weight providing tension to the belt.
3.
Tighten the torx screw (A) to secure the motor in place.
NOTE: If table saw with belt tension adjusted function, only
the technician can do the adjustment.
For assistance with your machine, visit our website at www.DeltaMachinery.com for a list of service centers or call Delta Power
Equipment Customer Care at 1-800-223-7278.
FAILURE TO START
If your machine fails to start, check to make sure the prongs on the cord plug are making good contact in the receptacle, and check
reset button on power switch housing. Also, check for blown fuses or open circuit breakers in your power line.

MAINTENANCE

Keep this area free of dust and
Power Equipment
®

TROUBLESHOOTING

Wear certified safety equipment for eye, hearing and
respiratory protection while using compressed air.
For best performance use a shop vacuum or blower to keep
saw blade area, the dust collection system, the guarding
system and rails free of saw dust and other debris.
To clean cast iron tables of rust, you will need the following
materials: a medium sized scouring pad, a can of spray
lubricant and a can of degreaser. Apply the spray lubricant and
polish the table surface with the scouring pad. Degrease the
table, then apply the protective product as described above.
Keep the worm gears free of dust and debris
WORM GEARS:
buildup. Blow out area regularly with compressed air. Use a
lithium-based multipurpose grease as needed on these gears.
CLEAN SAWDUST BUILDUP OUT OF CABINET PERIODICALLY:
Debris can also be removed from the saw from below
NOTE:
the throat plate, inside the dust port.
FIGURE 46
32
A