Maintenance; Replace Cartridge; Clean Cartridge Contacts - Reiner jetStamp 790 Manual De Instrucciones

Ocultar thumbs Ver también para jetStamp 790:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 96
jetStamp 790/790 MP

5. Maintenance

5.1. Replace Cartridge

When using special ink (MP), observe the notes in the operating instructions.
CAUTION
Health risks if ink is swallowed.
Don't swallow!
f
Keep cartridge out of the reach of children!
f
Replace Cartridge
Take jetStamp 790 from charging station
f
Press [MODE] until [INKJET] appears in the display menu bar.
f
Press [INKJET].
f
The print carriage moves into a central position.
Push the locking rail
f
Take the old cartridge
f
Take the new cartridge
f
from nozzles
When using standard ink hold the small felt pad
f
14
nozzles
until some ink appears on the felt.
Insert cartridge
f
Pull the locking rail
f
Press [INKJET].
f
The print carriage moves to the stamping position.

5.2. Clean Cartridge Contacts

Clean Cartridge Contacts
In rare cases, contamination at the cartridge contacts
Remove cartridge
f
Clean cartridge contacts
f
that may have been slightly moistened with ethanol (spirit).
84
Fig.
C
+
E
10
as far back as it will go.
13
out of the print carriage.
13
from its packaging and remove the protective film
14
or clip.
13
9
at handle bar
10
forward again until it locks into place.
Fig.
A
13
.
17
at the cartridge
4
.
15
that is provided, against the cartridge
in print carriage.
+
C
+
E
17
may cause defective print results.
13
and the printing carriage with a soft cloth
16

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Jetstamp 790 mp

Tabla de contenido