Technical Data - Reiner jetStamp 790 Manual De Instrucciones

jetStamp 790/790 MP

7.2. Technical data

Technical data
Stamping time
Stamping cycle
Print capacity per cartridge
Standby time per battery charge
Operating time per battery charge
Battery charging time
Dimensions, stamp only
Dimensions, charging station
Total height
Weight, stamp
Weight, charging station
Ambient temperature for operation
With standard cartridges
With MP cartridges
Ambience temperature f. storage
With standard cartridges
With MP cartridges
Ambience temperature f. transport
With standard cartridges
Height above sea level
With MP cartridges
Humidity for operation
With standard cartridges
With MP cartridges
Humidity f. storage
With standard cartridges
With MP cartridges
Power supply
Mains voltage
Noise level
Protection type
approx. 0.7 seconds
> 2 seconds
approx. 300,000 characters
6 days
approx. 500 prints
approx. 6 hours
(W x H x D in mm) 96 x 77 x 170
(W x H x D in mm) 115 x 141 x 35
195 mm
approx. 446 g (with cartridge)
approx. 370 g
+ 10 °C to + 40 °C
+ 10 °C to + 40 °C
+ 10 °C to + 40 °C
+ 10 °C to + 25 °C
- 5 °C to + 55 °C (up to 24 hours)
0 to 3000 metres:
- 20 °C to + 25 °C (up to 12 hours)
10 % to + 80 % relative humidity
8 % to + 80 % relative humidity
10 % to + 90 % relative humidity
30 % to + 70 % relative humidity
through supplied power supply unit
230 V ~ 50 Hz / 0,4 A AC
< 60 dB (A)
(Workplace related emission value
in accordance with ISO 7779)
IP20
GB
89