Leaving Program Mode; Starting And Stopping The Centrifuge; Starting The Centrifuge - OHAUS Frontier FC5515 Manual De Instrucciones

TM
Frontier Centrifuge FC5515/FC5515R
A-1
3.5.3

Leaving program mode

To leave the program mode just press the key "Prog/Setup" (11) (refer to figure 25). Then inside the display
"Time/Prog" the word "programm" appears.
Set the display to "programm--" (M10) with the adjusting knob (1).
3.6

Starting and stopping the centrifuge

3.6.1

Starting the centrifuge

You can start the centrifuge either with the "Start" key (9) (refer to figure 26) or the "Quick Spin" key (8).
By the "Start" key (9) you can start stored runs or runs with manually pre-selected parameters.
When the respective pre-selected running time has ended the centrifuge will stop automatically.
By the "Quick Spin" key (8) you can start runs, which will last just a few seconds.
By pressing the "Quick Spin" key (8) the centrifuge accelerates up to the pre-selected revolution.
In the display "Time/Prog" (A-3) the passed running time is indicated from the date of pressing the "Quick Spin"
key (8).
By releasing the "Quick Spin" key (8) the centrifuge stops and the running time is indicated until the opening of
the lid.
M3 M4
Figure. 25
Figure. 26
A-3
M10
A-3
EN-13
11
1
12
9
1
8