Procedures For Transporting - Clarke Fusion 27 Manual Del Operador

PROCEDURES FOR TRANSPORTING

How To Put The Machine In A Van Or Truck
WARNING:
1. Make sure the loading ramp is at least eight (8) feet long, and strong enough to support the machine.
2. Make sure the ramp is clean and dry.
3. Put the ramp in position.
4. Turn key switch "ON".
5. Align the machine on a level surface ten (10) feet in front of the ramp.
6. Put the traverse speed in the "HI" position.
7. Push the control handles toward the machine all the way.
8. Push the machine to the top of the ramp.
9. Turn the key switch "OFF".
10. Fasten the machine to the vehicle.
How To Remove The Machine From A Van Or Truck
1. Make sure there are no obstructions in the area.
2. Make sure the unloading ramp is at least eight (8) feet long and strong enough to support the machine.
3. Make sure the ramp is clean and dry.
4. Put the ramp in position.
5. Unfasten the machine.
WARNING: The machine is heavy. Make sure you use two able persons to assist in
moving the machine down the ramp.
6. Turn the key switch "ON".
7. Carefully and slowly, pull the machine to the top of the ramp.
8. Put the traverse speed in the "HI" position.
9. As the machine begins to travel down the ramp, push the control handles toward the machine to
maintain a slow downward speed.
Clarke ®
Operator's Manual - Fusion 27 Battery Burnisher
The machine is heavy. Make sure you use two able persons to assist
the machine in climbing the ramp.
EN
- 11 -