Tabla de contenido
Publicidad
MACHINE CONTROLS
NOTE: Reference figures 1, 2 and 3 on page 20.
Key Switch (See Figure 1, Item "A")
The key switch turns "ON" the power to the control panel. "0" is "OFF" and "1" is "on".
Traverse Speed (See Figure 1, Item "B")
The speed control varies from low to high speed. To increase the speed, turn the knob to the right. To de-
crease the speed, turn the knob to the left.
Head Position Switch (See Figure 1, Item "C")
The head switch has three positions: "Up" positions the pad driver up; "Down" positions the pad driver on the
floor. The middle position stops the actuator. The head motor operates only when the head is down and the
machine is traversing.
Pad Pressure Meter (See Figure 1, Item "D")
The pad pressure meter indicates the relative pressure of the pad on the floor. Do not continue to run the
machine when the meter is in "red" area. This will trip the pad motor circuit breaker.
Control Handle (See Figure 1, Item "E")
The control handle is located at the rear of the machine. It controls the direction of the machine. Push forward
to go forward. (See Figure #2, page 9). Pull back to move in reverse. (See Figure #3, page 9).
Circuit Breakers (See Figure 1, Item "F"-"H")
The circuit breaker reset buttons are located on the rear cover, below the control handle. The breakers are
located as follows:
Item F - Pad Motor (90A)
Item G - Traverse Motor (30A)
Item H - Actuator Motor, Brush Head (5A)
If a circuit breaker trips, determine which motor is not operating and turn the key switch "OFF". Wait five
minutes and push the reset button back in. Turn the key switch "ON", and try again. An authorized service
person should be contacted if the breaker trips again.
Hour Meter (See Figure 1, Item I)
The hour meter indicates the number of hours the machine has operated. It runs only when the machine is
moving forward or reverse.
Charge / Battery Meter (See Figure 1, Item J)
The charge/battery meter indicates the battery is being charged when the charger is plugged into a live outlet
and it indicates the amount of charge left in the batteries while they are being discharged. It will shut the pad
motor off when the battery voltage gets too low.
Clarke
®
Operator's Manual - Fusion 27 Battery Burnisher
EN
- 17 -
Publicidad
Tabla de contenido
