Baxtran ARD Manual De Usuario página 30

all the groups to "10 Ω". Now connect an end of the multimeter to "E-" and with the other end check every group of the "E-"
A, B, C and D. You must at least realize 8 measures and finally disconnect the multimeter.
3. Insert the socket to the indicator and connect it.
4. Place the weight in the frontal part, in the middle and in the back part of the forklifts, check that the value of the weight is the
same, if it is not so, you must adjust a little the groups C and D in the plate of the circuit:
- If the value is not correct when the load is placed in the frontal part of the forklift, the user must adjust "D +" of the
group D, following the direction of the hands of the clock if the variations are small and against the direction of the hands
of the clock if the variations are bigger.
- If the value is not correct when the load is palced on the back part of the forklift, the user must adjust "C +" of the
group C, contrary to the direction of the hands of the clock dor small variations and following the same direction than the
hands of the clock if the variation is larger.
Note: this procedure of adjustment is possible only when the error is small, on the contrary, the user must not use this method.
The user must also check that the load cells are intact and loose, and make sure that the forklifts do not get into contact. It is
also important to bear in mind that when the value is not exact, the user must adjust just the groups C and D of the plate and the
groups A and B of the potentiometer . If the user do not do this, the hand pallet can not be adjusted correctly.
30
USER'S MANUAL ARD EN