Solving Problems; Introduction; Instruction For Use - Baxtran ARD Manual De Usuario

SPECIFICATIONS OF THE HAND PALLET

SOLVING PROBLEMS

MALFUNCTION
The fork cannot be raised to
its maximum height.
The forklift does not raise.
The forklift can not go down-
wards.
Spillage of oil.
The valve of unload does not
work.

0. INTRODUCTION

1.1. INSTRUCTION FOR USE

1. Please keep the scale in a cool dry place. Do not store it at high temperature.
2. Do not allow any liquids to come into contact with the scale. If necessary wipe the scale with a dry soft cloth.
3. Avoid objects impacting with the scale. Do not drop loads onto the scale or subject the weighing pan to any strong shock loads.
4. The load placed on the weigh pan must not exceed the maximum weighing capacity of the scale.
5. If the scale is not going to be used for some time, please clean it and store it in a plastic bag in dry conditions. A desiccant sachet
may be included to prevent any moisture building up.
Maximum capacity
Length of the forklift
Width of the forklift
Height of the forklift
Weight
CAUSE
The hydraulic oil used is not the correct one.
Hydraulic oil needed.
Dirty oil.
Keep the bolts too near or the screws too tightened,
so that the valve remains open.
There is aire in the hydraulic bomb.
The placement of the goods on an only side or the
overload, causes a damage on the pistons or the
body of the hydraulic bomb.
The forklifts has been raised during a period of time
too long, and this has caused that the oxidation of
the blocks of movement of the pistons.
The bolt and the screw are not placed in the correct
position.
Ageing or flaws in the seals.
Some pieces are broken.
Due to the dirty oil the valve cannot be closed her-
metically.
A piece of the hydraulic system is damaged or
broken.
Air has mixed with oil.
Seal aged or damaged pieces.
The bolt or screws is not placed in its correct po-
sition.
2000 kg
1150 mm
550 mm/ 685 mm
≤80 mm
95-105 kg
Supply of oil.
Supply of oil.
Change the oil.
Adjust the bolts and the screws.
Extract the aire.
Replace the pistons for a bigger ones.
Lower the forklift to a minimum position when it is
used and lubricate the rib.
Adjust the bolt or screw.
Update.
Update.
Change the oil.
Revise and change the wasted pieces.
Extract the air.
Update.
Adjust the bolt or screw.
USER'S MANUAL ARD
APPROACH
EN
31