Power Supply; Advanced Functions; Checking Battery Voltage; Configuration Auto Stand By - Baxtran ARD Manual De Usuario

HOLD WEIGHING MODE
key two times, display shows "Hold"
1. Press
2. Press key to start the HOLD mode.
3. When choose this mode, user needs to press
4. Take off the object and press
5. Press key to exit HOLD mode and move back to weighing mode.
ACCUMULATION MODE
1. Press key three times, display shows "A C C"
2. Press key to confirm.
Manual accumulation
When choose this mode, user needs to press
data; take off the object and wait until zero, then put other object to continue accumulate data.
Press key to overview the total accumulated numbers and total accumulated weight; display will shows total accumulated
numbers then shows the total accumulated weight.
Scale will back to accumulation mode after showing the total accumulated numbers and weight.
Press key to exit accumulation mode and move back to weighing mode.

1.7. POWER SUPPLY

POWER SELECTION
_ 6V4Ah rechargeable battery
_ 110V or 220V AC/DC adaptor
POWER CONSUMPTION
_ Approximately DC 17mA (Scale)
_ Approximately DC 37mA (Scale + Display backlight)

2. ADVANCED FUNCTIONS

2.1. CHECKING BATTERY VOLTAGE

When scale is on and at zero and stable, long press
sill shows the battery voltage for 3 seconds ten back to weighing mode.

2.2. CONFIGURATION AUTO STAND BY

When scale is on and at zero and stable, long press
Then press key to confirm and back to weighing mode.
34
key after the objects are put on pan and the scale is stable.
key the until back to zero.
key after the objects are put on pan and the scale is stable to accumulate the
key around 3-5 seconds (beeper sounds) then release the key, display
key enter the auto back light setup, use
USER'S MANUAL ARD
key to enable or disable.
EN