Division Setting; Decimal Point Setting; Maximum Capacity Setting; Zero Point Calibration - Baxtran ARD Manual De Usuario

3.1. DIVISION SETTING

Display shows "d x", then press
Then press key to confirm, and enter the decimal point setting.

3.2. DECIMAL POINT SETTING

Display shows "p x", then press
enter the maximum capacity setting.

3.3. MAXIMUM CAPACITY SETTING

Display showsa " FULL " around 2-3 seconds then display shows "000.000", the decimal point was set
as 3 decimal points, then press
number, then press
the maximum capacity.
Then press key to enter calibration setting.

3.4. ZERO POINT CALIBRATION

Display shows "CaL 0", do not put any objects on the pan when display shows this, then scale will move to next calibration
setting.

3.5. SECOND POINT CALIBRATION

Display shows "00.000" (the decimal point was set as 3 digits)
Put on the weights on the pan which will be calibrate as second point then use
in circle to select the digits that will increase the number, then press
Then repeat the above moves until display shows the numbers which is equal to the weights put on the pan.
Press key to confirm calibration finished.
36
key to select 1, 2, 5, 10, 20, 50.
key to select 0, 0.0, 0.00, 0.000, 0.0000, P .00000. Then press
key to move the flashing digits to the right in circle to select the digits that will increase the
key to increase the number until the number appears, then repeat the above moves until display shows
USER'S MANUAL ARD
key to move the flashing digits to the right
key to increase the number until the number appears.
EN
key to confirm, and