Baxtran ARD Manual De Usuario página 26

ARD
disconnect the multimeter.
3. Insert the socket to the indicator and connect it.
4. Place the weight in the frontal part, in the middle and in the back part of the forklifts, check that the
value of the weight is the same, if it is not so, you must adjust a little the groups C and D in the plate of
the circuit:
- If the value is not correct when the load is placed in the frontal part of the forklift, the user must
adjust "D +" of the group D, following the direction of the hands of the clock if the variations are
small and against the direction of the hands of the clock if the variations are bigger.
- If the value is not correct when the load is palced on the back part of the forklift, the user must
adjust "C +" of the group C, contrary to the direction of the hands of the clock dor small variations
and following the same direction than the hands of the clock if the variation is larger.
Note: this procedure of adjustment is possible only when the error is small, on the contrary, the user must not
use this method.
The user must also check that the load cells are intact and loose, and make sure that the forklifts do not get
into contact. It is also important to bear in mind that when the value is not exact, the user must adjust just
the groups C and D of the plate and the groups A and B of the potentiometer . If the user do not do this,
the hand pallet can not be adjusted correctly.
Manual de usuario
ES FR ENG
25