RIDGID R4512 Manual Del Operador página 20

ASSEMBLY
INSTALLING THE CASTER SET TO THE LEG
STAND
See Figure 17.
 Slide the caster set into the leg stand, aligning the holes
in the caster assembly with the holes in the leg stand.
NOTE: Position the pedal as shown, so that it will be on
the left of the saw when the saw is upright.
 Locate the following from the small fastener pack:
Bolts (M8 x 16 mm) ....................................................... 8
 Insert the bolts into the holes in the leg stand and through
the holes in each caster.
 Using a 5 mm hex key, securely tighten the bolts.
 Position the feet on the stand by pressing them into place.
INSTALLING RIP FENCE STORAGE BRACKETS
See Figure 18.
 Remove the pre-installed bolt and nut from each bracket.
 Insert a bolt through the hole in each bracket, aligning it
as shown with the hole in the stand.
 Thread the nut over the bolt. Using a 5 mm hex key,
securely tighten each bolt.
SETTING THE SAW UPRIGHT
See Figure 19.
NOTE: The saw is heavy and requires several people for
this procedure.
 Tilt the saw until it rests on the back side of the cabinet.
 Raise saw carefully until it sits upright.
 To raise the saw table, step down on the pedal until it
locks.
 Roll the table saw to the desired location making sure
the surface is firm and level.
 Pull up on the pedal to slowly lower the table saw.
CASTER
ASSEMBLY
SOCKET
HEAD BOLT
FEET
BRACKET
BOLT
PEDAL
Fig. 17
20 - English
NUT
TO LOWER
Fig. 18
Fig. 19