RIDGID R4512 Manual Del Operador página 48

ADJUSTMENTS
TO ADJUST THE MITER GAUGE
See Figure 76.
You can set the miter gauge at 0° and plus or minus 45°
with the miter gauge stop pin and adjustable stop screws.
NOTE:
The miter gauge provides close accuracy in angled
cuts. For very close tolerances, test cuts are recommended.
 Loosen knob and pull out on stop pin to rotate miter
gauge base past stop screws.
 Loosen the lock nut of the 0° stop screw at the stop pin
with a 8 mm wrench.
 Place a 90° square against the miter gauge rod and the
miter gauge base.
 If the rod is not square, loosen the knob, adjust the rod,
and tighten the knob.
 Adjust the 0° stop screw until it rests against the stop pin.
 Adjust the plus and minus 45° stop screws using a 45°
triangle and the steps above.
TO CHECK AND ADJUST THE ALIGNMENT OF
THE RIP FENCE
See Figure 77.
The rip fence must be parallel to the saw blade and the miter
gauge grooves.
WARNING:
A misaligned rip fence can cause kickbacks and
jams. To reduce the risk of injury, always maintain
proper rip fence alignment.
 Unplug the saw.
 Remove the blade guard, riving knife, and anti-kickback
pawls. Raise the blade by unlocking the height adjusting
handwheel and turning it clockwise.
 Verify the blade is parallel to the miter gauge groove as
described in the Adjusting the Blade Parallel to the Miter
Gauge Groove (Removing Heel) section in Operations.
 Move the rip fence near the saw blade (about three inches
away) and lock the rip fence in place with the locking
handle.
 Mark beside one of the blade teeth at the front of the
blade. Using a ruler, measure the distance from the inside
face of the blade tooth to the to the inside face of the rip
fence.
NOTE: For greater accuracy, place the marked blade
tooth on top of the ruler.
 Turn the blade so the marked tooth is at the back.
 Move the ruler to the rear and again measure the distance
from the inside face of the blade tooth to the inside face
of the rip fence. If the distances are the same, the blade
and the rip fence are parallel.
MITER
GAUGE ROD
45° ADJUSTABLE
STOP SCREW
48 - English
MITER
GAUGE BASE
LOCK
NUT
0° ADJUSTABLE
STOP SCREW
CLAMP
SCREW
BLADE
TOOTH
BLADE
RULER
SCREWS
KNOB
STOP
PIN
Fig. 76
RIP FENCE
SCREWS
LOCKING
HANDLE
Fig. 77