Changing Motor Voltage - RIDGID R4512 Manual Del Operador

Sierra de mesa de 254 mm (10 pulg.)
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ELECTRICAL
WARNING:
To prevent possible electrical hazards, have a
qualified electrician check the line if you are not
certain that it is properly wired.

CHANGING MOTOR VOLTAGE

See Figures 2 - 4.
WARNING:
Electric shock can kill. To reduce the risk of
serious personal injury, never connect plug
to power source until all assembly steps are
completed.
NOTE: The table saw is prewired at the factory for 120 V,
60 Hz. Use the following procedures to change motor voltage
from 120 V to 240 V. This is an optional procedure to be
completed after the saw has been fully assembled.
 Unplug the saw.
 Remove the 6 screws that secure the rear panel of the
saw. Remove the panel.
 Lower the motor to its lowest point.
 Located on the top of the motor is the junction box.
Remove the phillips screw at the back of the junction
box then lift off the cover.
 Remove and discard the electrical tape from the wire
connectors. Remove wire connectors.
 Reconnect the leads.
 Reinstall the wire connectors and wrap each wire with
two layers of new UL listed electrical tape.
 Recheck your wiring with the wiring diagrams.
 Reinstall the junction box cover using the phillips screw.
 Cut off the 120 volt power cord plug and replace it with
a 3-prong 240 volt, 15 amp. UL listed plug.
 Connect the power cord white and black leads,
respectively, to the "hot" plug blade terminals. Connect
the power cord green grounding wire to the plug ground
prong terminal.
 Reinstall the rear panel.
 Plug your table saw into a 220-240 V, 15 amp., 3-prong
receptacle. Make certain the receptacle is connected to
a 240 V, AC power supply through a 240 V branch circuit
having at least a 15 amp capacity and protected by a
15 amp time-delay fuse or circuit breaker.
FOR USE WITH 220-240 VOLT
240V
9 - English
GROUNDING
PIN
COVER OF
GROUNDED
OUTLET BOX
RED
YELLOW
BLACK
WHITE
3
2
1
4
G
L1
L2
GREEN
BLACK
WHITE
RED
BLACK
WHITE
YELLOW
2
3
1
4
G
L1
L2
GREEN
BLACK
WHITE
Fig. 2
Fig. 3
Fig. 4

Publicidad

Tabla de contenido
loading

Tabla de contenido