Dis)Assembling Rear Wheels; Storage - Vermeiren Trigo T-line Manual De Instrucciones

2.5

(Dis)Assembling rear wheels

To remove the rear wheels
1.
Press and hold button (43) while sliding the wheel axle out of the hole of the frame.
2.
Repeat this for the other wheel and place the wheelchair gently on the rear frame
tubes.
To install the rear wheels
1.
Take one of the rear wheels and lift the wheelchair on
one side.
2.
Press and hold button (43) while sliding the wheel into
the axle bushy.
3.
Release the button to lock the wheel. Make sure it clicks
into place.
4.
Repeat this for the other wheel.
5.
Ensure that both wheels are firmly secured.
2.6

Storage

Make sure that your wheelchair is stored in a dry environment to prevent mould
from growing and the upholstery from being damaged, see also chapter 5.
43
7
EN
Trigo T
2019-02
NL
Before use
PL
CS