Camber Angle Adjustment Of The Rear Wheels; Footplate Height - Vermeiren Trigo S Manual De Instalación

3.2.7 Camber angle adjustment of the rear wheels

The camber angle of the rear wheels is adjustable in 4 positions (0°, 2°, 4°, 6°) by adjusting the
angle of the rear wheel attachment cube in the rear wheel support:
1. Remove the rear wheel, using the quick release system.
2. Remove both bolt-nut connections (23) from the rear wheel
attachment cube (24).
3. Adjust the angle of the attachment cube (24) relative to the rear
wheel support (25). *
4. Fasten the attachment cube (24) in the correct angle by firmly
tightening the bolt-nut (23) connections in the corresponding
holes.
5. Remount the rear wheel.
6. Repeat for the other wheel. Make sure that both rear wheels are adjusted to the same
camber angle.
*
The attachment cube has been fitted with four sets of two matching
holes. Choose the set that corresponds to the required camber angle as
shown in the picture.

3.2.8 Footplate height

Trigo S (steps of 10 mm)
1. Remove the M6 screw from the back of the footrest (26).
2. Slide the footplate (27) up/down in the front-frame tube (28)
until the desired height. Make sure the holes of the inner and
outer tube align.
3. Replace the M6 screw (26).
4. Repeat for the second footrest. Make sure that both footrests
are set to the same height, and that they are firmly secured.
Trigo T (stepless)
1. Remove the M6 screw from the back of the footrest (26).
2. Slide the footplate (27) up/down in the front-frame tube (28)
until the desired height.
3. Replace the M6 screw (26).
4. Repeat for the second footrest. Make sure that both footrests are set to the same height,
and that they are firmly secured.
27
9
Trigo S, Trigo T
2019-11
Assembly and adjustments
23
28
3
26
EN
NL
PL
CS
24
25