Selecting The Spray Setting; Adjusting The Desired Spray Setting (Fig. 6); Adjusting The Material Volume (Fig. 7); Spray Technique - WAGNER W 600 Manual De Uso

GB
three different spray jet settings can be chosen on the spray gun, depending on the
application and target object.

Selecting the Spray Setting

Fig. 5 A = vertical flat jet
Fig. 5 B = horizontal flat jet
Fig. 5 C = circular jet

Adjusting the desired Spray Setting (Fig. 6)

With the union nut (1) slightly unscrewed, turn the air cap (2) to the desired spray-setting
position (arrow) . Then tighten the union nut .
WARNING!

Adjusting the Material Volume (Fig. 7)

Set the material volume by turning the regulator on the trigger of the spray gun
- turn to the left
+ turn to the right

Spray technique

•
T he spray result depends heavily on the smoothness and cleanliness of the surface to
be sprayed . Therefore the surface should be carefully prepared and kept free of dust .
•
C over all surfaces not to be sprayed .
•
C over screw threads or similar parts of the target object .
•
I t is advisable to test the spray gun on cardboard or a similar surface to find the
correct setting .
Important: Begin spraying outside of the target area and avoid interruptions inside
the target area .
•
T he spray movement should come from the arm, not just from the wrist . This ensures
that a uniform distance is maintained between the spray gun and the spray surface
during the spray operation . Select a distance of 5 - 15 cm, depending on the desired
spray jet width .
Fig. 8 a: CORRECt Even distance to the object .
Fig. 8 b: INCORRECt Uneven distance causes uneven coating .
•
M ove the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting .
•
A n even movement of the spray gun results in an even surface quality .
30
 for horizontal surfaces
 for vertical surfaces
 for corners, edges and hard-to-reach
surfaces
Danger of injury!
Never pull the trigger while adjusting the air cap.
lower material volume

higher material volume

W 600