Shroud Removal; Battery Removal; G.single-Post Height-Adjustable Armrests - Quickie Pulse Serie Manual De Instrucciones

Q UI C KIE PU LS E
E. SHROUD REMOVAL
The plastic protective shroud can be removed for adjustment or servicing.
1. Remove the top shroud
a. Remove the Seat (Section T previous page).
b. Remove the six screws(A) that hold the shroud to the frame.
c. Once all of the screws have been removed, the shroud should be free to remove.
2. Remove the rear shroud
a. Remove the two rear shroud screws.
b. Pull downward at the top of the rear shroud, then lift up and off.
3. Replacing the front, or rear shroud
a. Position the shroud and hand thread a few screws to hold the shroud in place.
b. You can then insert the other screws while moving the shroud to line up the holes.
c. Be sure not to tighten screws too much, because it could fracture the plastic.
F. BATTERY REMOVAL
1. To remove the batteries before transporting or servicing:
a. Carefully flip back the seat (see Section T Seat removal)
b. Remove the shroud (see Section E Shroud removal) .
c. Unplug the main power connect (B)
d. Lift the batteries out of the frame using the battery strap as a lifting handle.
2. Battery installation
• See section X. (Batteries) for installation
Batteries may weigh up to 55 lbs. Care must be taken to avoid injury when lifting up on bat-
tery straps.
G. SINGLE POST HEIGHT-ADJUSTABLE ARMRESTS (Optional)
1. Adjusting armrest receiver (forwards or backwards)
a. Loosen the 3 bolts (C) on the receiver clamp.
b. You can move the armrest and receiver forwards or backwards for a universal fit.
c. Tighten the hardware when adjustment is complete(C).
2. Adjusting Armrest Receiver Fit (tighten or loosen fit)
To tighten or loosen the fit of the outer armpost in the receiver:
a. Loosen the four bolts (D) on both sides of the receiver.
b. With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
c. Continue the pressure on the receiver and tighten the four bolts.
3. Adjusting Inner Armpost Fit
a. Two set screws(E) are installed in the outer armpost.
b. Turn the set screws in or out until the desired fit is achieved.
61
62
63
WARNING
XI. DEALER SERVICE & ADJUSTMENT
64 65
31
A
B
E
61
62
63
64
C
D
65
119832 Rev. E