Seat Height Adjustment; W.seat To Floor Height/Pre-Tilt Positioning - Quickie Pulse Serie Manual De Instrucciones

Q UI C KIE PU LS E
2. Back Support Frame Width Adjustment
a. After measuring the width adjustment in the seating area, Remove the front securing
hardware (A) from the adjustment tube (B) on the stabilizer bar.
b. The Stabilizer bar can be adjusted in 1" increments(1/2' on each side) to match the
width change in the seating area.
c. Replace the Stabilizer bar, recheck the measurement and make sure your backposts
are straight and parrallel. Tighten the adjustment screws (A)
V. SEAT HEIGHT ADJUSTMENT
a. After removing the seat, remove the lockout Pin (A) from all 4 seat mount posts.
b. In most cases, select the desired seat height by moving all four post up the same dis-
tance, so the seating system is level following the adjustment.
c. Reinsert the hardware and remember to replace the Lockout pin(A).
W. SEAT TO FLOOR HEIGHT/PRE-TILT POSITIONING
Your ASAP II seating system can be adjusted to many different seat to floor heights, and pre-
tilt positioning depending on your specific configuration. Seat to floor heights and Pre-tilt
positioning should only be altered by a trained medical professional. For the correct Pre-tilt
settings and seat to floor heights, in relation to specific configurations of the Pulse please
Refer to the seat to floor matrix in the Pulse service manual before changing any of the fac-
tory settings.
DO NOT increase the front post height independent from the rear posts when providing
seating pre-tilt.
NOTE–
For chairs configured with SPOT tilt, do not increase the Pre-tilt greater than 3 degrees.
For chairs configured with seat elevator, do not increase the Pre-tilt greater than 3 degrees.
For chairs configured with SPOT tilt and seat elevator, do not increase the seat-to-floor
height greater than 1" fron the lowest position.
For chairs configured with SPOT tilt and recline, do not increase the seat to floor height
greater than 18", and do not increase the pre-tilt greater than 0 degrees.
119832Rev. E
84 85
86
WARNING
36
XI. DEALER SERVICE & ADJUSTMENT
87 88
Front Seat post
Rear Seat post
A
B
Hole 1
Hole 2
Hole 3
Hole 4
Hole 5
Hole A
Hole B
Hole C
Hole D
Hole E
85
A
87
88