Installing Pad Driver Or Brush - Tennant 5100 Manual Del Operador

INSTALLING PAD DRIVER OR BRUSH

1. Select recommended pad or brush that best
meets your cleaning needs.
NOTE: Consult an authorized distributor for
pad/brush recommendations.
2. Attach pad to pad driver before mounting driver to
motor hub. Secure pad with plastic centerlock ring
(Figure 5).
FIG. 5
3. Plug power cord into a grounded wall outlet
(Figure 6).
Grounded Outlet
Grounding
Edge/hole
(220V/230V/240V)
FIG. 6
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
4. Turn main power switch on (Figure 7).
FIG. 7
Tennant 5100 (05- -05)
Home Find... Go To..
5. Place the pad driver/brush on the floor in front of
the scrub head (Figure 8).
FIG. 8
6. Tilt the machine back on it's rear wheels and
center the scrub head down over the pad
driver/brush (Figure 8).
7. IMPORTANT STEP: Release the brush lift pedal
from the transport position (Figure 9). Align the
motor hub down inside the pad driver/brush.
FIG. 9
8. Pull the triggers to engage the pad driver/brush
(Figure 10). Make sure the front wheel is in the
UP position.
NOTE: When a pad driver/brush is not installed, make
sure to keep the machine in the transport position to
prevent skirt damage.
FIG. 10
NOTE: Before installing pad driver or brush make sure
mounting surface is clean. A clean surface will ease
pad driver removal later.
OPERATION
7