Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
C) TECHNICAL CHARACTERISTICS:
1) GENERAL:
- Channels
- Modulation modes
- Frequency ranges
- Antenna impedance
- Power supply
- Dimensions (in mm)
- Weight
- Accessories supplied
- Filter
2) TRANSMISSION:
- Frequency allowance
- Carrier power
- Transmission interference
- Audio response
- Emitted power in the adj. channel
- Microphone sensitivity
- Drain
- Modulated signal distortion
3) RECEPTION:
- Maxi. sensitivity at 20 dB sinad
- Frequency response
- Adjacent channel selectivity
- Maximum audio power
- Squelch sensitivity
- Frequency image rejection rate
- Intermediate frequency rej. rate
- Drain
: 40
: AM/FM
: from 26.965 MHz to 27.405 MHz
: 50 ohms
: 13.2 V
: 115 (L) x 180 (H) x 35 (D)
: 0,8 kg
: Electret microphone with support,
mounting cradle, screws.
: ANL (Automatic Noise Limiter) built-in
: +/- 300 Hz
: 1 W AM / 4 W FM
: inferior to 4 nW (- 54 dBm)
: 300 Hz à 3 KHz in AM/FM
: inferior to 20 µW
: 10 mV
: 1,7 A (with modulation)
: 1,8 %
: 0.5 µV - 113 dBm (AM/FM)
: 300 Hz à 3 kHz in AM/FM
: 60 dB
: 5 W
: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
: 60 dB
: 70 dB
: 500 mA nominal / 800 mA maximum
D) TROUBLE SHOOTING:
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR TRANSMISSION
IS OF POOR QUALITY:
-
Check that the antenna is correctly connected and that the SWR is properly
adjusted.
-
Check that the microphone is properly plugged in.
-
With the «push-to-talk» switch activated, the display flashes. Release the «push-to-
talk» switch, then re-press it to go into transmission.
2) YOUR CB RADIO WILL NOT RECEIVE OR RECEPTION IS POOR:
-
Check that the squelch level is properly adjusted.
-
Check that the volume is set to a comfortable listening level.
-
Check that the microphone is properly plugged in.
-
Check that the antenna is correctly connected and that the SWR is properly
adjusted.
-
Check that you are using the same modulation mode as your correspondent.
3) YOUR CB WILL NOT LIGHT UP:
-
Check the power supply.
-
Check the connection wiring.
-
Check the fuse.
E) HOW TO TRANSMIT OR RECEIVE A MESSAGE:
Now that you have read the manual, make sure that your CB Radio is ready for use
(i.e. check that your antenna is connected).
Choose your channel (19, 27).
33
Publicidad
Tabla de contenido
