Machine Set-Up; Attaching The Thread Guide Pole; Placing The Foam Pads And Spool Holders - Janome 1100D Professional Manual De Instrucciones

q
1
2
e
3
SECTION II

Machine Set-up

Attaching the Thread Guide Pole

1. Insert the thread guide pole into the spool pin
base located at the back of the machine. Make
sure the slot of the thread guide pole grips the rib
in the base hole.
2. Pull the thread guide pole to its highest position.
Align the thread guide portion with the spool pins.
w

Placing the Foam Pads and Spool Holders

Remove the spool holders. Place the foam pads and
the spool holders. The foam pads help stabilize the
spools of thread.
Both thread cones and spools of thread can be used.
q Foam pad
w Spool holder
1. Thread cones
For thread cones, use the spool holders. Place the
thread cone on the spool holder and push the cone as
far as it will go.
e
2. Spools of thread
For spools of thread, remove the spool holder. Place
the spool of thread on the spool pin and attach the
spool cap.
e Spool cap
3. Spools of decorative thread (specialty threads)
Place the spool directly on the foam pad to prevent the
thread from slipping underneath the spool.
14