Introduction; Intended Use; Parts Description - Parkside PFDS 33 B2 Instrucciones De Montaje

Flux-Cored Wire Welder PFDS 33 B2

Introduction

Congratulations! You have
chosen a high-quality unit from
our company. Familiarise your-
self with the product before using it for the first time.
In addition, please carefully read the instructions for
use and the safety instructions below. Initial opera-
tion of this tool must be performed by trained per-
sonnel.
KEEP OUT OF THE REACH OF CHILDREN!

Intended Use

This unit is intended for self-shielded flux-cored arc
welding using the appropriate wire. Additional gas
is not required. The inert gas is contained in a pow-
dered form in the wire, is therefore fed directly into
the arc, and this makes the tool wind-resistant while
working outdoors. Only suitable wire electrodes may
be used for the unit. Intended use also involves ob-
serving the safety instructions, assembly instructions
and operating instructions in the instruction manual.
The applicable accident prevention regulations are
to be adhered to as strictly as possible. The unit
may not be used:
- in insufficiently ventilated spaces,
- in a damp or wet environment,
- in explosive environments,
- for the purposes of thawing pipes,
- in the vicinity of people with pacemakers and
- in the vicinity of inflammable materials.
Only use the product as described and for the
specified purpose. Keep these instructions in a safe
place. When passing this product on to others, please
also include all the documents. Any use other than
the intended is prohibited and potentially dangerous.
Damages resulting from noncompliance or misuse
are not covered by the warranty and are not included
in the manufacturer's liability.
Residual risk
Even if you use the unit correctly, there will always
be residual risks. The following hazards can arise
due to the design and performance of this flux-cored
arc welding unit:
- Eye damage due to being dazzled,
- Touching hot parts of the unit or the work piece
(burns),
- In the case of insufficient protection, a risk of
accidents and fire exists due to sparks or slag,
- Harmful gas and smoke emissions in the case of a
lack of air and / or insufficient extraction in enclosed
spaces.
Reduce the residual risk by using the unit carefully
and correctly and following all the instructions as
stated.

Parts Description

Cover for wire feeder unit
1
Carrying strap
2
Mains plug
3
Earth cable with earth terminal
4
Main switch ON / OFF (including mains
5
control lamp)
Control lamp for overload protection
6
Burner nozzle
7
MIN / MAX switch for welding current setting
8
1 / 2 Switch for welding current setting
9
Adjustment wheel for wire feeder
10
Burner
11
Burner button
12
Cable assembly with direct connection
13
Welding nozzle (0.6 mm)
14
Welding nozzle (0.8 mm)
15
Handle
16
Welding nozzle (0.9 mm)
17
Flux-cored wire welding coil (wire reel)
18
Ø 0.9 mm / 450 g
Chipping hammer with wire brush
19
Welding helmet after assembly, consisting of:
20
Dark welding lens
21
Mask
22
Mounting clip
23
Protective glass locking mechanism
24
Roll holder
25
Introduction
GB/IE 29