Lenco Concerto DIR-2000 Manual Del Usuario página 17

View View settings settings
View View settings settings
• • • •
View the information of the current connected network:
Active connection, MAC address, Wlan region, DHCP, SSID, IP
address, Subnet mask, Gateway address, Primary DNS and
Secondary DNS.
Wlan region
Wlan Wlan Wlan region region region
• • • •
Select the Wlan region to obtain the optimal Wlan
connectivity: Canada, Spain, France, Japan, Singapore,
Australia, and Republic of Korea.
Manual Manual
Manual Manual settings
• • • •
Choose a wireless network connection and enable or disable
DHCP (Dynamic Host Configuration Protocol).
Network
Network Network Network profile
• • • •
The device has memory function to memorize the last four
wireless networks that it has been connected to. The device
will automatically connect to one of them whichever could be
found and is available.
The list of registered networks will be displayed. You can
delete some unwanted networks by turning and pressing OK
and then choose YES to confirm.
Keep Keep Keep Keep the the network the the
• • • •
If you choose to keep the network connected, the WiFi will not
disconnect even if the device is in standby mode. Otherwise, the
connection will only available when the device is switched on. This
option allows the device to be ready for DLNA streaming in any
operating mode. Details for DLNA streaming, please refer to Section
5.6.
settings settings
settings
profile
profile profile
network network connected network connected connected connected
17