dirna Bergstrom bycool blue line FLAT RENAULT Instrucciones De Montaje página 19

FLAT
RECOMMENDATIONS
FOR ASSEMBLY
•Before starting the assembly read the instructions
and follow them during the installation process.
• Use suitable tools for each operation.
ELECTRICITY
• Switch off the ignition key.
• Disconnect the battery before starting the
assembly.
• Secure the connection of the electrical compo-
nents by checking that they fit correctly.
WARNING :
When installing the evaporative unit in the
ceiling, protect the upper part of the cabin with
a cloth or sheet to prevent scratching. When
installing Bycool Flat in the ceiling, bear in mind
that cabins are normally fitted with a hatch and
have a structure which can withstand the weight
of the unit. However, if this is not so and it is
necessary to open up the ceiling, or should the
hatch material not be sufficiently resistant (e.g.
fibre, plastic, etc) the installer must decide, under
his sole responsibility, on the need to reinforce
the ceiling in order to prevent deformation,
breakage, incoming water, etc, and use the means
necessary to this end.
Air conditioning for vehicles
Torque Wrench set
Allen Wrench Set
Spanner 10, 13, 14
Scissors
Tape Measure
DOCUMENTATION WHICH COMES
WITH THE EQUIPMENT:
• Assembly Instructions: 220.AA7.0007
• User Manual: 220.AA7.0003
• Troubleshooting: 220.AA7.0004
• Guarantee: 220.AA1.0010
WARNINGS :
• Part no. 17 from the List of Parts Supplied must be
replaced every 12 months.
• Dirna Bergstrom, s.l. will not be held responsible
for any faults arising from inappropriate handling or
installation of the equipment, or due to modifications
or replacements carried out without our written
authorisation.
• See guarantee procedure for the product included
in Troubleshooting.
• See the equipment User Manual for the correct
operation of the remote control and the control
panel.
19
Tools
ES
EN