Maintenance And Cleaning; What If There Are Problems; Replacement Parts And Wearing Parts - Beurer ELLE MPE 58 Manual De Instrucciones

Drying varnished nails
1. Insert the mains plug into the socket.
2. Press the ON/OFF button to switch on the device.
3. To switch on the dryer function, press the dryer button.
The fan inside the housing will begin to rotate.
4. Insert your your nails varnished with nail varnish into the opening in the device (with your nails facing upwards).
5. As soon as your nail varnish has dried, switch the device off. To do this press the ON/OFF button and pull the
mains plug out of the socket.

5. Maintenance and cleaning

Replacing the fluorescent tubes
If one of the four fluorescent tubes ceases to work properly, replace all four fluorescent tubes.
You can order the required fluorescent tubes from Customer Services.
Warning
Before replacing the fluorescent tubes, pull the mains plug out of the socket!
Important
Only insert UV-9W-L type fluorescent tubes into the device.
To replace the fluorescent tubes, follow the steps contained in section "3. Initial use".
Cleaning
Warning
Before beginning cleaning, pull the mains plug out of the socket!
• Clean the base plate after each use.
• Clean the surface of the device and the base plate carefully using a slightly damp cloth only.
• Do not use any cleaning agents or solvents.

6. What if there are problems?

Problem
Device will not switch on.
UV nail gel does not dry.
Nail varnish does not dry.
UV fluorescent tube does
not light up.

7. Replacement parts and wearing parts

Replacement parts and wearing parts are available from the corresponding service address (according to the service
address list). Please state the corresponding order number.
Designation
UV fluorescent tubes, 4 units
Possible cause
Mains plug not plugged in.
No voltage at mains socket.
Treatment time with UV light too short.
Treatment time in dryer too short.
UV fluorescent tube not correctly in-
serted.
UV fluorescent tube faulty.
Item number and/or order number
163.290
Solution
Insert the mains plug into the socket.
Check your fusebox.
Set a longer UV light treatment time.
Keep your varnished nails in the dryer for
longer.
Check that the UV fluorescent tube has
been correctly inserted.
Insert a new UV fluorescent tube.
10