Attaching Polishing Accessories; Working With The Machine - Festool SHINEX RAP 150-14 FE Manual De Instrucciones

14 and are screwed directly onto the spindle.
Procedure
Rotate the polishing pad [2-2] loosely on the

tool spindle.
Press and hold the spindle stop [2-1].

Turn the tool spindle [2-3] until it stops and

firmly screw the polishing pad.
2
1
2-3
2
3
Observe the following instructions:
– Do not use the machine when the electronics are
faulty because the machine may operate at ex-
cessive speeds. An absence of the smooth start-
up function or speed control indicates that the
electronics are faulty.
– Do not overload the machine by pressing with ex-
cessive force! The best polishing results are
achieved with moderate application pressure.
The polishing capacity and quality are mainly de-
pendent on the selection of the correct polish.
– Hold the machine with two hands, one on the mo-
tor housing and one on the gear head or addition-
al handle [1-6] to ensure safe guidance.
12
2-1
2-2

Working with the machine

Attaching polishing accessories

StickFix is a system that simplifies the attachment
of polishing accessories (felt, sponge, sheepskin) to
the polishing pad [2-2] where they are retained by
an adhesive coating.
Attaching the additional handle
The additional handle [3-1] can be screwed onto ei-
ther the right or left of the gear head.
3
 The rubber support points [4-1] provide extra
stability when the machine is set down.
4
4-1
1
3-1
2