DieHard DH111 Manual Del Usuario página 8

THE STATUS SCREEN
NOTE: Tap any
information.
A. Charge Indicator Ring – The color
of this ring and the amount of the
circle that is filled indicates the
charge level. A completely green ring
indicates the battery is fully charged.
This corresponds to the percentage
displayed in the center.
B. Charge Time – The amount of time
needed to charge the battery when it
was first connected.
C. Charge Pause Switch – Tap the sliding
switch to start or pause the charging
process. The current status is shown
above the switch. You can pause the
charge while watching the voltage drop
to see if there is a power draw from the
battery. The charging process will not be
reset unless the charger is unplugged
and plugged in again. NOTE: This
charger is also a maintainer and it is not
necessary to stop the charging process;
the charger will automatically switch to
maintenance mode when the battery is
fully charged.
D. Connected to Wi-Fi – When the
icon is green, this indicates the charger
is connected to Wi-Fi. When the charger
is not connected to Wi-Fi, the icon
turns gray. Tap the
strength.
E. Connected to AC – When green, this
indicates the charger is plugged into
a live 120V AC outlet. If the charger is
unplugged from the AC, the charger
will power itself off of the battery for five
minutes, sending out a loss of power
signal to the app. When no AC power is
detected, the icon turns gray.
F. Connected to Battery – When green,
indicates that the battery is properly
connected to the charger. When clamps
are reversed or not connected, the icon
turns gray.
icon to bring up more
to check the signal
G. Battery Voltage – Shows battery
voltage. This voltage varies throughout
the charging cycle, but gives an
indication of the health of the battery.
If the value goes below 12.5V during
Float or Maintain modes, this could
indicate excessive draw on the
battery by the vehicle or the battery
approaching the end of its life.
H. Charge Amps – Shows the current the
charger is putting into the battery.
I. Charger Temperature – Shows the
charger's temperature status. The
charger will automatically lower
the charge current if it detects the
temperature is higher than normal.
Use the house icon
HOME screen.
A
G
• 8 •
to return to the
B
D E F
C
H I